In the majority of cases, most people spend quite a lot of money buying their lift truck. Therefore, it is very essential to take good care of it in order to protect your investment well into the long run. It is really a good idea to know the procedures which are carried out during taking care of and maintaining this equipment.
Amongst the best ways to tell how good the engine is working is by starting the forklift up and listening carefully to see how it runs. For example, if there are any knocks or misses, the equipment is defective and this should raise several concerns. In addition listen closely for any squealing noise which come from the belts because these sounds would provide you with a wealth of information.
When performing maintenance, several of the main parts you will have to pay attention to comprise the horn, safety warning devices, the lights, the gauges and the overhead guard. Any faulty parts or burnt out light bulbs should be replaced as soon as they are noticed. It is also vital to check the wiring.
When the above components have been inspected carefully, proceed to the battery compartment to be able to see if the terminals are clean. If the terminals are not clean, be sure to clean them well. Each battery cell must be checked so as to ensure the fill level is topped up to the regulated amount.
An oil change is the next step to drain all the oil out of the equipment and after that change the filters. The transmission filter, fuel filters and the hydraulic filter should be frequently replaced. Prior to fitting them, be sure to write the date on the new filters by utilizing a permanent marker in order to keep track.
After the oil change is done and the filters have been replaced, a visual inspection of the drive axle needs to be done. If there is a grease fitting on the axle make certain to apply some grease. Check the belts on the engine for any frays or cracks. If you find any, fix the issue accordingly. Afterwards, inspect each and every other component of the equipment like the wheels. If any type of problem or fault is detected, be sure to deal with it immediately in order to make sure the machinery is working at its safest and optimum levels.